individual prices for resellers
4 years warranty
Made in the EU
9in/26out standalone multiswitch for distribution of 8 SAT IF signals including terrestrial for up to 26 users
With this multiswitch, you can receive all satellite TV signals from 2 different satellites simultaneously at 26 TV sets !!
For indoor use only.
HDTV and UHDTV compatible
Parameter Condition Value
Frequency range LNB inputs 950-2300 MHz
Terr. input 5-862 MHz (passive)
40-862 MHz (active)
Outputs 5-2300 MHz (passive)
40-2300 MHz (active)
13/18 V + 0/22 kHz, DiSEqC 1.0 or 2.0
Insertion loss Sat. 5 dB avg.
Terr active 8 dB avg
Terr. passive 25 dB avg
Sat. inputs isolation
20 dB min
Maximum input level* Sat. 90 dBµV avg
Terr. 100 dBµV avg (passive)
90 dBµV avg (active)
Maximum output level* Sat. 85 dBµV avg
Terr. 75 dBµV avg (passive)
82 dBµV avg (active)
Power consumption From each receiver 50 mA (18 V)
From internal power supply 3 W (passive)
4.5 W (active) + LNB
Terr. preamplifier supply
150 mA max at 12V DC
47.0 x 15.2 x 8.7 cm
(power cord length 130 cm)
-30 ~ +70 °C
*Terr.: EN 50083-3/60dB IMA3 [dBµV]; SAT: EN 50083-3/35dB IMA3 [dBµV]
Multiswitches are controlled by receiver using analog and DiSEqC 1.0 commands:
command sent by receiver
selected input of multiswitch
13 V, 0 kHz, DiSEqC A (1) A
18 V, 0 kHz, DiSEqC A (1) B
13 V, 22 kHz, DiSEqC A (1) C
18 V, 22 kHz, DiSEqC A (1) D
13 V, 0 kHz, DiSEqC B (2) E
18 V, 0 kHz, DiSEqC B (2) F
13 V, 22 kHz, DiSEqC B (2) G
18 V, 22 kHz, DiSEqC B (2) H
Multiswitches are not compatible with Monoblock LNBs
If higher than available number of user outputs is required, simply use two multiswitches instead of one, routing LNB outputs via signal splitters
If terrestrial band is used, terminate all unused outputs by 75 ohm loads
Switching between active and passive processing of terrestrial band is performed by lever No. 1 of configuration DIP-switch
22 kHz tone required for Quad LNB can be disabled by DIP-switch
DC supply for preamplifier of terr. antenna is limited to 150 mA max. The supply is disconnected if higher load or short circuit is applied to terrestrial input. To keep power consumption at minimum level is however recommended to include external DC block if short-circuit conditions should persist on terrestrial input
We accept payment by: via PAYPAL. Once an auction finishes we will send an Invoice with detailed payment information along with the goods.
Goods are dispatched once cleared payment has been received. Please note we cannot offer collections as stock is shipped directly from our stockholder base.
Dispatches are normally made 8:00am – 17:00pm Mon to Fri as soon as cleared payment is received.
Terms of Sale
We represent that the goods are as they are described in the above listing. Genuinely faulty goods will be replaced or money refunded. We must be advised of any faulty goods within 30 days of receipt.
We believe the information on this page to be accurate; such information is subject to change without notice. We are not responsible for any inadvertent errors. No warranty or representation (express or implied) concerning the accuracy of the information provided is given and customers should satisfy themselves that any product choice made is suitable for their intended purpose or use.
We pride ourselves on our customer service. In the rare event that you have a problem with your item please email us first before leaving negative feedback.
We are here to assist you between 07:00 to 17:00 weekdays. To contact us via email, please use the Ebay mailing system allowing us 12-24 hours to respond to your inquiry.