This is the COMPLETE 3-part Reusable Coffee Filter for Keurig coffeemakers, consisting of Lid, Filter Basket and the cup-like basket holder.

This is NOT just a replacement filter basket, as sold in many other listings.


Reusable K-Cup coffee filter exclusive to the Keurig Home Brewing System
Allows users to use their own gourmet ground coffee in a Keurig brewer
Works in all Keurig home brewers including B30, B31 B40 Elite, B50 Ultra, B60 Special Edition and B70
Does not fit B100, B131, B100P, B2000/3 or any Keurig Office or commercial brewers

Free Shipping is for all 50 States,

To Use your Reusable Coffee Filter:

Open the Filter Holder by turning the lid counter-clockwise and remove the Filter Basket.

Wash the Filter Holder, lid and Filter Basket with warm soapy water prior to first use, then rinse and dry thoroughly.

Remove the K-Cup Holder from your brewer. To do this, first lift the handle of the brewer, and then grasp the outside housing of the K-Cup Holder with the thumb and index finger of one hand and push up from below with the index finder of your other hand while holding the housing firmly.

Fill the Filter Basket with your desired amount of coffee. In general, roasters recommend 2 tbsp. of coffee for every 6 oz. of water used. The basket (filled to the top of the mesh) holds approximately 2.5 tbsp. of coffee so that you can adjust to your personal preferences. There are line markings on the inside of the filter that designate 1 tbsp. and 2 tbsp. Do NOT fill the Filter Basket past the top of the mesh or tamp the grinds. Be sure there are no coffee grinds remaining on the upper rim of the filter.

Place the Filter Basket in the Filter Holder and slightly twist the lid, turning clockwise.

Place the Filter Holder in the K-Cup Assembly Housing in the brewer (remember, you must remove the K-Cup Holder first).

Lower the handle and brew as you normally do by pressing the desired brew size button.

After brewing, lift the handle and remove the Filter Holder from the brewer.

Open the Filter Holder by turning the lid counter clock wise. Lift the Filter Basket, discard the grounds and rinse out the Filter Basket and Holder. The Filter Holder and Filter Basket may be HOT so please use caution.

To replace the brewer’s original K-Cup Holder, lift the handle of the brewer and place the K-Cup Holder into the Assembly Housing, align the three holder tabs with the corresponding housing slots, and press the holder into the housing to snap it into place.