Safety Tags "Caution + Danger" - Red/Yellow-Lot of 40-Pre-wired-Numbered-New

Caution and Danger Safety Tags-Red and Yellow-Lot of 40-Pre-wired-Numbered-NewThis lot of 40 Caution and Danger tags are comprised of three perforated parts each signifying a different stage in the process. The individual tags are numbered with the same number for ease of reference and then each other tag is numbered sequentially. Each tag is pre-wired with a reinforced eyelet. The tag is cardstock. Parts A and B are in red and C is in yellow. The entire tag measures approximately 4 inches wide and 11 1/2 inches long. There is verbiage on both sides of each section. Section A (in Red with black lettering):Front:NumberINSTRUCTIONSPERSON TAGGING THIS MACHINE FOR REPAIR OR INSTALLATION WILL REMOVE THIS STUB AND FORWARD IT TO THE SAFETY DEPARTMENT. SAFETY INSPECTOR IS TO BE NOTIFIED WHEN WORK IS COMPLETED.APPROVEDLines for: Date, time and Safety Inspector's signatureIn bold: Forward to Safety Dept.Back:Lines for the following: Date, Time, Name and No. of Machine, Location, Work to be Performed, TAGGED BY, Dept., SignatureSection B (in Red with black lettering):Front:NumberIn bold: DANGERDO NOT OPERATE UNTIL APPROVED BY THE SAFETY DEPARTMENTIn small caps: Work performed on this machine or equipment will be inspected and approved as safe by supervision of each department when work is completed.Each departmental approval line includes Dept., Supervision Approvals and Date. The following are the designated Supervision Approvals: Maintenance, Production, Electrical Engineering, Process Engineering, Ergonomics and Safety.Back:See Other SideGENERAL INSTRUCTIONS MACHINE OR EQUIPMENT MUST BE TAGGED AND INSPECTED.Lines for the following information: NAME AND NUMBER OF MACHINE, Location of Machine, Work to be Performed, W.O. Number, Date and Time Machine is Tagged, Dept. and Tagged By.OK FOR TRYOUT ONLY - YELLOWTAG INSTALLED CHECKBOX YES CHECKBOX NOAPPROVED BY SAFETY DEPARTMENTSection C (in Yellow with black lettering)Front:NumberIn Bold: CAUTIONTHIS MACHINE HAS BEEN RELEASED FOR (IN BOLD) TRY-OUT PURPOSES ONLY AND IS NOT TO BE PUT INTO FULL OPERATION UNTIL THE CONDITIONS NOTED ON THE REVERSE SIDE HAVE BEEN COMPLETED AND APPROVED BY THE SAFETY DEPARTMENT.Lines for: Date and Safety Inspector signatureBack:Lines for: Plant No., Safety Tag No., Machine No.The Supervisor will review and document safe operating procedures, including lock out, with employees for the Try-out and Debugging process. This equipment will not be released for full production until listed unsafe conditions are corrected.Checkbox Employees have been trained.Approved by Supervisor signature, Safety Inspector signatureThe top of the tags say: "Rev. (8-02) FH-485These tags are new and have not been used. They are bound together by the wires but do not come in any packaging. Shipping weight: 2 lbs.