Designed for use in the transmission of vehicles over 100,000 km. Purpose: Processing of mechanical gearboxes, transfer cases, car bridges.
Added to gear oil. Dosage: One bottle of 95 ml / 2 liters of gear oil. The action of the product is aimed at intensive "treatment" of worn-out parts, filling micro-defects of the surface and restoration of worn-out surfaces of mechanisms.
As a result of using this product:
- Improves the smoothness of the ride and gear shifting
- Reduced vibration and noise
- The resource of the mechanism is extended

Series: RESTORATION
FORSAN nanoceramics ™ Transmission is a nanotechnology product that rebuilds and protects parts
transmission units. Designed for bridges, gearboxes, manual transmissions of used cars
more than 100,000 km.
The result of application is:
Reduced vibration and noise
Improved ride and gear shifting
Reduced fuel consumption
Reduced wear during "cold driving"
TRANSMISSION PROCESSING TECHNIQUE
Transmission processing is performed ONCE 2 according to the table (Table 1).
Table # 1. FORSAN nanoceramics consumption rate table Transmission

Transmission oil volume (l) Dosage2
for full processing of the node
from 0.5 to 1 ½ bottle
from 1 to 2 1 bottle
from 2 to 3 1½ bottles
from 3 to 4 2 bottles

Processing order:
1. Warm up the transmission after driving 5-10 km.
2. Prepare a bottle of FORSAN nanoceramics ™ Transmission.
3. Make sure the vial is at room temperature and shake vigorously for 1-2 minutes.
4. Add the contents of the bottle to the case of the gearbox, transfer case, drive axle through
oil filler neck or hole. Dosage according to the table.
5. If sediment remains in the bottle, add a small amount of regular oil, shake thoroughly and
pour into the oil filler neck.
6. After filling, you need to drive 5-10 km using all gears, including reverse (for several
minutes every).
ATTENTION!
- FORSAN nanoceramics ™ vial Transmission is not intended for automatic transmissions.
RECOMMENDATIONS:
- To increase the effect and stabilize the result of application, it is recommended to make additional
transmission treatment - every 50,000 km or 1 year, whichever comes first.
- To increase the effect and stabilize the result, it is recommended to carry out a complex treatment of the car,
using additional vials of FORSAN nanoceramics ™ Engine series: RESTORATION.
- If additives with molybdenum, graphite, etc. were used. it is necessary to change the oil.
CONTRAINDICATIONS:
- Limiting wear of parts (more than 70%), the presence of obvious mechanical defects in the engine and transmission.
1When the transmission is worn more than 50%, repeat the treatment after 5000-7000 km. mileage without oil change.
2 Use an additional bottle of FORSAN nanoceramics ™ to obtain the required dosage. Transmission Series:
RESTORATION.