For complex processing of gasoline, diesel engines of new cars and cars with a mileage of up to 100,000 km.

For turbocharged engines with ANY mileage.

The set consists of 3 bottles of 95 ml (FOR APPLICATION IN THREE STEPS). Each bottle of 95 ml is applied in one step.

The composition dosage of 3 x 95 ml is designed for use in vehicles with an engine displacement of up to 2300 cc. If the engine displacement is over 2300 cc, it is necessary to increase the amount of the composition according to the instructions. To increase the dosage use additional single vials FORSAN nanoceramics motor series Protection 95 ml

As a result of using this product:

- Reduces fuel consumption;

- Compression in the cylinders is leveled;

- Reduces harmful emissions of exhaust gases (СО / CH);

- Facilitates "cold start"

Series: PROTECTION
FORSAN nanoceramics® engine kit - a nanotechnology product that provides protection against wear of parts
internal combustion engine of a car. Designed for all types of gasoline and diesel engines (including
number of turbocharged) cars with less than 100,000 km mileage.
Equipment:
FORSAN nanoceramics® Engine 95ml - 3 pcs.
TECHNIQUE OF PROCESSING OF PETROL, DIESEL ENGINES
The engine is processed in THREE STEPS1
with an interval between treatments of at least 1000 km.
Dosage according to the table (Table 1).
Table # 1. FORSAN nanoceramics® consumption rate table Engine
Engine displacement (cc) Dosage2
per STAGE Total for a complete engine processing cycle
up to 1200 ½ bottle 1 ½ bottle
from 1300 to 2300 1 bottle 3 bottles
up to 3000 1 ½ bottle 4 ½ bottle
up to 4000 2 bottles 6 bottles
up to 6000 3 bottles 9 bottles
The order of processing at each stage:
1. Warm up the engine to 60-80 С.
2. Determine the dosage according to the table (Table 1).
3. Make sure the vial is at room temperature and shake vigorously for 1-2 minutes.
4. Add the contents of the bottle to the engine oil through the oil filler neck in the amount
corresponding to the engine size of the car (see table).
5. If sediment remains in the bottle, add a small amount of regular oil, shake thoroughly and
pour into the oil filler neck.
6. Let the engine idle for at least 20 minutes.
7. Further, the operation of the car takes place in the running-in mode of at least 100 km.
ATTENTION! Low oil pressure or Check Engine indication may appear. Replace
oil and oil filter and continue to operate until the next stage of processing, according to the instructions.

The result of application is:
Reduced fuel consumption
Improving the environmental performance of exhaust gases (CO / CH)
Reduced vibration and noise
Reduced wear during "cold start"
Optimization and leveling of compression in cylinders
Power increase
RECOMMENDATIONS:
- To increase the effect and stabilize the result of application, it is recommended to carry out a complex treatment
engine in three stages - every 50,000 km or 1 year, whichever comes first.
- If additives with molybdenum, graphite were used, the oil and oil filter must be changed.
CONTRAINDICATIONS:
- The presence of obvious mechanical defects in the engine
- High engine oil consumption - more than 1 liter per 2000 km of run
- When using other wear reducing agents, consult with
manufacturer JSC "Nanoprom"
1 Routine engine oil changes can be carried out between processing steps.
2 Use an additional bottle of FORSAN nanoceramics® Engine Series:
PROTECTION