Nano Washing Glue: This adapter is using nano high-viscosity glue, once glued to the phone, it is difficult to peel off. If the glue surface is used for a long time or stained, just rinse the glue surface with water, and then continue to use it after drying. (Please save the transparent film on the glue, and stick it back when not using the bracket)Install Easier: The adapter is suitable for all models of mobile phones, no longer have to worry about whether the size of the mobile phone is. You can directly align the lens to the aiming hole, press it on the nano glue, and finally install it on the eyepiece and tighten the eyepiece clip.Lightweight: Weighs only 0.18Ib. It’s made of high-strength PA plastic which is lighter than many others on the market and is more convenient to carry when going out.Compatible with Multiple Devices: The adapter can be used on spotting scope, microscope, binoculars, monoscope, astronomical telescope, night vision spotting scope.Applicable Eyepiece Size: Suitable for eyepieces with an outer diameter of 0.98-1.77 inches. The surface of the eyepiece holder is covered with a soft EVA pad to avoid scratching and damaging the device. Say goodbye to the traditional model, Adhesive Adapter gives you more flexibility to adjust the position of your phone. The wash design allows the stand to be used repeatedly. Please note: 1. Be sure to wait until the rubber is completely dry before using it. 2. Do not touch the rubber surface directly with your fingers to extend its life. 3. Please save the transparent film on the glue, and stick it back when not using the bracket. Track Page Views WithAuctiva's Counter