Gasket former "Ultra" Gray
is one-component, vulcanizing at
room temperature with a compound designed
to create durable gaskets, finally
formed in the working position, intended
for use in mechanical assemblies and parts.
The material of which the gasket is made dries when
interaction with a humid air environment and forms
resistant to external influences, flexible gasket made of
silicone rubber. The product does not lose its
properties over time, excellently resists
adverse weather and thermal conditions at
this without hardening, not forming folds or cracking.
Specially designed to work in extreme
modes and installations on engines with close
bolts spaced apart (usually
found in foreign engines). Provides
excellent resistance to adverse
exposure to lubricants and water-glycol
mixtures. Has a certificate of the manufacturer of complex
equipment.
PRODUCT ADVANTAGES
• High durability in engines operating in
extreme modes
• Improved resistance to adverse
exposure to lubricants
• Safe for sensors, non-corrosive
• Works in place of most standard
gaskets
• Can be used as a gasket,
finally formed in working position or in
as a gasket seal
• Not flammable, non-toxic
• Virtually odorless
APPLIES
• Cylinder block cover
• Pallet box
• Oil pan
• Covers of the mechanism of timing gears
• In the differential cover
INSTRUCTIONS FOR USE
As a gasket, finally formed in
working position
1. Clean the surfaces. Permatex Shaper
gaskets are recommended for use on
most types of surfaces, excluding
plastic and painted surfaces.
2. For best results, degrease and
dry surfaces with with not
leaving traces and residue of solvent,
e.g. with Permatex solvent
"Cleaner of brakes and parts".
3. Cut the cap at the mark corresponding
required dispenser diameter - from 0.15875 cm
(1/16 in.) To 0.635 cm (1/4 in.). Most
often requires a 0.3175 cm (1/8
inches).
4. Remove the cap, perforated cap
tube or cartridge seal and put on the nozzle.
5. Apply silicone to one of the surfaces
continuous and even layer, primarily along
the inner perimeter and only then around
bolt holes as shown below:
6. Immediately, while the silicone has not hardened, mount
surface. Fasten or tighten the parts in
according to individual technical
requirements.
7. After the silicone has hardened, re-tighten
no fasteners required.
For use as a sealant
gaskets
1. Repeat steps 1-4 above.
2. Apply a thin layer of silicone to one of the
surfaces.
3. Place the traditional stamped gasket
on the silicone layer.
4. Apply a thin layer of silicone over
traditional stamped gasket.
5. Remove excess silicone from the edges of the surface and
mount parts.
Attention: It is not recommended to use this
product as cylinder head gasket
or a cylinder head gasket seal.

Completion of the repair
1. Wait for the material to harden on
dispensing tip or aerosol spray
to seal and protect it from contained in
air moisture. For reuse
it is necessary to remove the hardened material from
dosing tip or aerosol spray.
2. Remove uncured product from the surface
parts and tools using dry
matter / If the product solidifies,
it is necessary to break the appeared film with
using dry matter, remove it for a while
possibly, then remove the remnants of the material from
using Permatex Gasket Remover,
following the above procedure.