The PICkit 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers. The full featured Windows® programming interface supports baseline (PIC10F, PIC12F5xx, PIC16F5xx), midrange (PIC12F6xx, PIC16F), PIC18F, PIC24, dsPIC30, dsPIC33, and PIC32 families of 8-bit, 16-bit, and 32-bit microcontrollers, and many Microchip Serial EEPROM products. With Microchip’s powerful MPLAB Integrated Development Environment (IDE) the PICkit™ 2 enables in-circuit debugging on most PIC® microcontrollers. In-Circuit-Debugging runs, halts and single steps the program while the PIC microcontroller is embedded in the application. When halted at a breakpoint, the file registers can be examined and modified.
This PICkit 2 programmer has two types of ICSP connector for easy connectivitely to your board.
PICkit 2 Programmer-To-Go. This feature allows a hex file to be downloaded to the PICkit 2 to later program PIC microcontrollers without a PC!
The PICkit 2 Programmer software includes documentation and an easy Programmer-To-Go Wizard.
- Easy to use Windows® programming interface for programming Microchip’s Flash family of microcontrollers
- UART Tool software for direct serial communications with a microcontroller RX/TX pins through the PICkit 2.
- Logic Tool software for simple logic signal stimulus and monitoring, with a 3-channel logic analyzer.
List of supported devices:http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en027813
2) Bank transfer (bank account in Germany)
4) Google checkout